Iai xsel software10/25/2022 ![]() ![]() When the controller is set by connecting the Teaching Pendant to the gateway unit/SIO converter, the conditions shown below occur. (Note) When connected to the controller without AUTO/MANU switch, the conditions shown below occur. (Refer to 3.2, “Operations Using the Toolbar Buttons.”) ![]() * For the PCON, ACON, ERC2, ERC3, PSEP, ASEP and DSEP controller without AUTO/MANU switch, always set the MANU operation mode to “Monitor Mode 2” on the main window before disconnecting the Teaching Pendant from the controller. * After disconnecting the Teaching Pendant from the PCON, ACON, SCON, ROBONET, MSEP or MSCON controller with the AUTO/MANU switch, always turn the AUTO/MANU switch to AUTO. X The company names, names of products and trademarks of each company shown in the sentences are registered trademarks.ĭisconnection of the Teaching Pendant from the PCON, ACON, SCON ERC2, ERC3, ROBONET, PSEP, ASEP, DSEP, MSEP and MSCON Controller #Iai xsel software manual#X Using or copying all or part of this Operation Manual without permission is prohibited. X If you have any question or comment regarding the content of this manual, please contact the IAI sales office near you. X Information contained in this Operation Manual is subject to change without notice for the purpose of product improvement. IAI shall assume no responsibility for the outcome of any operation not specified herein. X The product cannot be operated in any way unless expressly specified in this Operation Manual. When using the product, refer to the necessary portions of the applicable operation manual by printing them out or displaying them on a PC.Īfter reading the Operation Manual, keep it in a convenient place so that whoever is handling this product can reference it quickly when necessary. #Iai xsel software manuals#The CD or DVD that comes with the product contains operation manuals for IAI products. ![]() This Operation Manual explains the handling methods, structure and maintenance of this product, among others, providing the information you need to know to use the product safely.īefore using the product, be sure to read this manual and fully understand the contents explained herein to ensure safe use of the product. 14.1 Parameter (Factory Default Setting) Initializing Method.12.6 Operations in Takt time calculation.12.4 Operation to Select Target Axis Number for Off Board Tuning.12.2 Guideline of Off Board Tuning Function.11.4 Operation on Test Run and Takt Time Calculation.11.3 Operation in Edit position data Window.Smart Tuning Function (Version V8.03.00.00 or Later) Initial Setting and Position Data Editing for SEP Controllers Editing Position Data on CON Controllers and Older Models 3.2 Operations Using the Toolbar Buttons. #Iai xsel software software#1.1 Items Supplied with This Software (Product Components). ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |